HLA SP3500R10 120-Inch 3500 Series Snow Pusher with Rubber Cutting Edge

Mid

No hydraulics required

HLA SP3500R10 120-Inch 3500 Series Snow Pusher with Rubber Cutting Edge

Overview

The HLA SP3500R10 is a 120-inch (10-foot) rubber-edge snow pusher from Ontario-based HLA Attachments. At 10 feet wide with a rubber cutting edge, this is suited to commercial operations on premium asphalt and concrete surfaces where scraping performance matters but surface damage cannot be tolerated. The rubber edge handles speed bumps and expansion joints without metal contact noise. Spring trip edge protects against frost heaves.

Canada Availability

Available in Canada through HLA Attachments and HLA Snow dealers. Ontario-manufactured.

Compare with: Arctic 9-Foot Box Snow Pusher for Skid Steers · Arctic Sectional Sno-Pusher 10-Foot Snow Pusher for Skid Steers · Arctic Snow and Ice 10 Foot Skid Steer Snow Pusher

Key Facts

Pusher width: 120 inches (10 feet)
Mouldboard height: 38 inches
Depth: 36 inches
Weight: approximately 1,200 lbs
Maximum operating weight of carrier: 15,000 lbs
Cutting edge: rubber
Spring trip cutting edge
AR400 skid bars
2-year commercial warranty
Hydraulic flow: none required — passive attachment, no auxiliary hydraulics

✓ Specs sourced from hlasnow.com · Last verified: March 2026

View on hlasnow.com →

See It in Action

Is This Right For You?

Buy if

You push snow on flat commercial lots, parking decks, or loading docks with a defined push perimeter
You don't have room or budget for a blower — pushers cost far less and maintain well

Skip if

Your site has no windrow drop zone — pushers pile snow that has to go somewhere
Wet, heavy Ontario snow is your primary challenge — heavy packs reduce machine traction with a full pusher

Also consider

Sectional pusher if your site has frost heaves or uneven pavement you need the wings to follow
Snow blower attachment if bank height from repeated pushes is becoming a problem

Machine Compatibility

Wide attachment — verify your machine's rated operating capacity (ROC) before ordering. Compatible with all skid steer brands via universal SSQA quick attach — no auxiliary hydraulics required.

About HLA in Canada

HLA Attachments is an Ontario-based manufacturer that designs and builds attachments in Waterloo, ON, with a dealer network spanning all provinces. Backed by a Canadian warranty and local parts availability, HLA is one of the most trusted names on Canadian job sites.

Care & Maintenance

Inspect the trip-edge blade for wear before each season and replace when worn below the wear indicator line — a worn-through trip-edge transfers full impact to the blade frame
Grease all trip-edge pivot and hinge points after every major pushing session, especially after work in extreme cold where grease migrates out of joints faster
Check side board welds for cracking after frost heave strikes — box sides bear significant impact forces during high-speed frost heave hits
Rinse salt off after every use and before extended storage — road salt accelerates rust on unpainted steel edges and frame members faster than people expect
Store off the ground on blocks or a pallet to prevent the cutting edge from sitting in standing water and rusting from below